Ironwood-electronics SBT User Manual Manuel d'utilisateur télécharger pdf (Page 6)

5 | P a g e S B T . d o c , R e v . C , 6 / 2 8 / 2 0 1 2 , VP

Tel: (800) 404-0204

www.ironwoodelectronics.com

Backing and insulation Plate

For all IC body sizes, stamped pin sockets require a rigid metal backing plate to prevent deflection of the target

circuit board due to a high normal force required to compress the stamped pins. If the backside of the target

PCB contains capacitors and resistors, a custom insulation plate with cavities cut for those components can be

designed. This insulation plate sandwiches between the backing plate and target PCB as shown in figure 4.

Figure 5 shows an example of a custom insulation plate.

IC Insertion/extraction

A vacuum pen is recommended for insertion/extraction of ICs. Figure 6 shows a typical vacuum pen. TL-

vacuumpen-01 can be purchased separately. Hand insertion of ICs and extraction using a small tweezers is also

acceptable.

Figure 5: Insulation Plate example drawing

Figure 6: Vacuum Pen with Attachments

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Ironwood-electronics SBT User Manual Manuel d'utilisateur Page 6